International Standardization Of Electrical SystemsAutomation systems are being integrated into modern production lines as well as into organizational management systems. Automation mechanisms can be difficult to change without significant loss. This is true even for companies that manufacture. All processes run smoothly due to this. Specific foreign documents specifically international standards have been created to assist with each step of the process. We offer a variety of worldwide ISO documents that cover both electrical and manual systems.
Small craft Remote mechanical steering systems (ISO 8848:2020) EN ISO 8848:2021
While the most advanced technology is becoming more automated, and human involvement in industrial processes is reduced, remote control can still be utilized. The technological guidelines are available in the form of international standards. One of them is EN ISO 848:2021. This document describes the specifications for remote-controlled cable steering systems. It also provides the interface point for jet drives and rudders. This document can be used for three types if steering systems that are compatible with various craft types.
Standard responsibility steering systems with two or one outboard motor installations of more than 15kW and both sterndrives/rudders.
* Light duty steering systems suitable for small craft using one outboard motor that ranges from 15 kW to 40kW.
Mini-jet steering isn't offered on personal watercrafts.
Note: You are able to swap standard and light duty steering systems. If the craft you are considering is for a lighter duty system, you may still be able to use the standard duty steering system. Standard duty systems does not permit you to choose a lighter duty steering system for your vessel. Mini-jet steering systems can only be used on minijet craft because they're mechanically different from other systems. This document doesn't address emergency steering methods.
The standard is very small in scope and only applies to specific categories. We recommend you read more about the standard and all the areas and parameters it applies to your use and application.
Small craft Non-fire-resistant fuelgas hoses (ISO 8469:2021) EN ISO 8469:2021
Electric vehicles have played a major contribution to technological advancements within the humanities. However, the usage of combustible materials has not been halted. This class is therefore an extremely sought-after one in international standards that regulate safety. EN ISO 8469.2021, is one of the most important international standards. The document describes the requirements and physical evaluations of non-combustible, non fire-resistant hoses that are used to convey gas, ethanol or diesel fuel, or fuel combined with FAME. It is designed to offer an operating pressure not exceeding 0,34MPa for hoses with an internal diameter below 10mm and a pressure of 0,25MPa for small craft with an inner diameter greater that 64mm. This is the case for small craft that are equipped with fuel systems that are permanently installed.
ISO 7840.2021 specifies the specifications for fire-resistant Hoses. ISO 10088:2013 contains specifications for permanently installed fuel systems. If you're thinking of purchasing the record for your vehicle, it's recommended to study the annotations. They are a fantastic option that allows you to build a complete complicated that meets the most current specifications and standards in the world market.
1 post • Page 1 of 1